Results Per Page | Showing 1-15 of 15 Results
| 1
Answer:
For all locks that use the T2 programming, the User Code length requirements are:
...
View Answer
Answer:
For all non-Networx cylindrical locks:
...
View Answer
Answer:
If an SQL Express 2012 installation results in a "Fusion Active Template Library (ATL)" failed status, proceed as follows:
...
View Answer
Answer:
See images below. Mounting the external door pull for Models 250 / 260, 700 / 710 and 715 is relatively simple. Packed inside the Model 707 Door Pull box is a mounting template (P3191). Use this template for drilling the correct...
View Answer
Answer:
1. Using the supplied template, drill the appropriate hole in the door in order to mount a CER-KD rim cylinder.
...
View Answer
Answer:
For single door installations, the backset is 2-3/4" measured from the edge of the door to the center of the 1-1/4" rim cylinder hole as indicated on the installation template (P5026) supplied with the unit.
...
View Answer
Answer:
The DL1200ET, DL1300ET and PDL1300ET will work with the Arrow S1200/1250, DCI 1200/1300, Von Duprin 22, Corbin ED8200 and the DORMA 5300 panic bar. Also works with the Von Duprin 33 series, but with the model 33A only right hand reverse (RHR)...
View Answer
Answer:
For a single door installation, the backset is 2-¾", measured from the edge of the door to the center of the 1-¼ rim cylinder hole shown on the installation template (part #P5026) supplied with the unit.
...
View Answer
Answer:
The hole diameter for the spindle shaft is 7/8".
View Answer
Answer:
On the paper template, draw a new line (parallel to the existing dotted line) that is 3/8" closer to the "Thru Holes" on the template. The image below shows these new lines in red color. Use these new lines in place of the existing dotted...
View Answer
Answer:
Models: Alarm Lock Exit Trim ("ET") Models DL1200ET, DL/PDL1300ET, DL1225ET, DL1250ET, DL/PDL1325ET, DL/PDL1350ET:
View Answer
Answer:
Yes - The templates below may be used for the DL3500-CR / PDL3500-CR (Supplement to WI1003 USA Mortise Door Template)
View Answer
Answer:
Yes, the included parts and dimensions are:
...
View Answer
40 Results Per Page | Showing 1-15 of 15 Results
| 1
